Wanted to try some simple stuff with a PSoC and I've got the large kit
from the 2006 World tour, the one with four experiment circuits on there.

Looking for schematics the closest I found was CY3209 which is very
similar but not 100%%, and all part designators are numbered differently.
Possibly the "old" kit from 2006 was CY3121 but not sure, there is no
info on the board itself. There is nothing on the Cypress site and
nothing on the CD we were given back then.

Anyone know where to find schematics and stuff for it?

--
Regards, Joerg

http://www.analogconsultants.com/

"gmail" domain blocked because of excessive spam.
Use another domain or send PM.

UN JERKS Again...

http://news.bbc.co.uk/2/hi/science/nature/7600005.stm

Personally I think I'll join PETA (People Eating Tasty Animals ;-)

...Jim Thompson
--
| James E.Thompson, P.E. | mens |
| Analog Innovations, Inc. | et |
| Analog/Mixed-Signal ASIC's and Discrete Systems | manus |
| Phoenix, Arizona 85048 Skype: Contacts Only | |
| Voice:(480)460-2350 Fax: Available upon request | Brass Rat |
| E-mail Icon at http://www.analog-innovations.com | 1962 |

Liberals are so ignorant...
They don't even know the definition of ignorant

http://www.youtube.com/watch?v=LlvUepMa31o

JF

we want to use an Antenna to transmit and receive signal. The Block
Diagram of our Demo can be found on the following link:
http://picasaweb.google.com/Hector.BIT/Technic#5242928559321154466
So, maybe a Switch or MUX is needed. Any suggestions? Thanks in
advance.
In this system, the frequency of carrier is from 1MHz to 10MHz. The
transmit power is very low but the voltage is approximately 100v by
resonance.

I would like to start with Atmel AVR's, so I need some cheap development
board. Something like this:
http://www.futurlec.com/ATMEGA8535_Educational_Board.shtml, max 100 USD.

Do you have any recomendation?

Not really the right newsgroup but since your family!

I was cooling my computer using oil and a refigerator compressor I tore out
of an old mini-refigerator I had back from school.

It was working well keeping my computer's temp at least 10 degree's or more
cooler(initially it would be at 10-15 degree's celsius and ramp up to about
30-35. Without the cooling it runs about 45-50(with oil) which is what it
runs with just air cooling.

Anyways what happaned was the compressor froze the water(Which is pumped
through the oil using copper tubing) because the pump stopped
working(basically... it's pumping at it's peak height). I didn't realize it
was froze so I tried lifting the ice carriage thingy(basically the expander
that actually get's cold in the fridge) and it broke releasing the gas(maybe
I shouldn't say that... will I be fined or have to pay some type of carbon
credits? Hopefully I won't get arrested).

Since the computer is running a bit too hot I want to salvage the idea. (bad
enough it's in oil which is distributed the heat almost completely among all
the components)