> Is there a 3/4" attachment for the Delta mortiser out there somewhere? I
> did a quick search of the usual sources, but only found CMT with a 3/4
> diameter shank. Unfortunately the Delta has a 5/8 shank. I'd need to make a
> lot of 3/4 square openings (too many to chisel) and I'd rather do it in one
> shot, as opposed to using the 1/2" and scooting it over. Anyone know whether
> these exist? Thanks, Mark

> On Mar 23, 1:22 pm, "mark" Nowhere.com> wrote:

>> Is there a 3/4" attachment for the Delta mortiser out there somewhere? I
>> did a quick search of the usual sources, but only found CMT with a 3/4
>> diameter shank. Unfortunately the Delta has a 5/8 shank. I'd need to
>> make a
>> lot of 3/4 square openings (too many to chisel) and I'd rather do it in
>> one
>> shot, as opposed to using the 1/2" and scooting it over. Anyone know
>> whether
>> these exist? Thanks, Mark

>
> I've picked up a few on ebay. it takes a while at the rate I lurk the
> 'bay, but I've gotten some good deals.

>Is there a 3/4" attachment for the Delta mortiser out there somewhere? I
>did a quick search of the usual sources, but only found CMT with a 3/4
>diameter shank. Unfortunately the Delta has a 5/8 shank. I'd need to make a
>lot of 3/4 square openings (too many to chisel) and I'd rather do it in one
>shot, as opposed to using the 1/2" and scooting it over. Anyone know whether
>these exist?

> On Sun, 23 Mar 2008 15:22:04 -0500, "mark" Nowhere.com> wrote:
>

>>Is there a 3/4" attachment for the Delta mortiser out there somewhere? I
>>did a quick search of the usual sources, but only found CMT with a 3/4
>>diameter shank. Unfortunately the Delta has a 5/8 shank. I'd need to make
>>a
>>lot of 3/4 square openings (too many to chisel) and I'd rather do it in
>>one
>>shot, as opposed to using the 1/2" and scooting it over. Anyone know
>>whether
>>these exist?

>
> My Powermatic chisels have a 3/4" shank.
>
> What about replacing your chuck with a 3/4" chuck?