You probably only need one of the components for you system - unless you
want all of them. Match up the PnP ID from TAP/PMQ (or in Device Manager
under XP Pro) with the the FBA PnP in one of the components. You can then
delete the other components, and keep the on you need for the system.
Regards,
Sean Liming
www.sjjmicro.com /
www.seanliming.com
XP Embedded Book Author - XP Embedded Advanced, XP Embedded Supplemental
Toolkit
"Richard Rosenheim"
discussions.microsoft.com> wrote in
message news:2B6F4175-A957-45F8-AF79-AA71626DCDC4@microsoft.com...> Thank you, both KM and Sean -- it's working (and at 1680x1050 resolution!)
>
> Basically, the issue was as Sean figured, the Hotkey poller service issue.
>
> Here's what I did to resolve the issue (for anyone else reading this
> thread):
>
> After receiving KM's reply, I created a clean install of XP and installed
> the video driver from the Files folder I created for the component. I
> discovered that there was two places in the CX_3815.inf file that
> specified a
> directory path of ".\B_32846". I modified the CX_3815.inf file so that
> the
> directory path was just "." That didn't get the driver working, but
> probably
> did help.
>
> After receiving Sean's reply, as outlined in the document he referenced, I
> went into my component and set every occurrence of StartName to
> "LocalSystem". That actually did the trick.
>
> Thanks again,
>
> Richard
>
>
> "Sean Liming (eMVP)" wrote:
>
>>>I created a custom component following the instructions in "How to Set
>>>up a
>>> New Repository"
>>>
http://msdn2.microsoft.com/en-us-library/ms913698(d=printer).aspx and
>>> by
>>> importing the CX_3815.inf file for the ATI Radeon 9250 video driver.
>>>
>>> I included the component in my build and the files included in the
>>> component
>>> are being installed to the System32 and System32\Driver folders.
>>>
>>> But, the ATI drivers are not being loaded. FBALog has the following
>>> lines
>>> in it:
>>> [PnpEnumThread: InstallDevice] SetupDiCallClassInstaller Error: 0x2,
>>> Device:
>>> RADEON 9250
>>> [PnpEnumThread: InstallDevice] SetupDiCallClassInstaller Error: 0x2,
>>> Device:
>>> RADEON 9250 - Secondary
>>>
>>> My understanding is that error 0x2 is a file not found error condition.
>>> [Suggestion to WPE developers: how about including the name of the
>>> missing
>>> file?]
>>>
>>> Every file in the ATI setup folder Driver\2KXP_INF\B_32846 was included
>>> along with the CX_3815.cat and CX_3815.inf files. This list of files
>>> also
>>> matches the files listed in the inf file. Dependency check does not
>>> report
>>> any files missing.
>>>
>>> At this point, I'm lost as to what file FBA is looking for. Can anyone
>>> give
>>> me any help in determing what file is missing?
>>>
>>> TIA
>>>
>>> Richard
>>
>>
>>
