Hi, i am trying to see where are some dll's to make it work my image. I run
dependency walker then when i wanna get in the Component Database and apply
a filter on CDM it appears an error that says "Run time error 381" invalid
property array index. I try to install again the WXPE and still appears the
same error.

Does anybody knows how can i fix it?

Or maybe you can help me with the dll's that i'm looking for.

version.dll, shlwapi.dll, mscoree.dll gdi32.dll, netapi32.dll, ole32.dll,
urlmon.dll, advapi32.dll.

Also i have the next question, who can i make the component for the drivers
that come with the motherboard (MSI Realtek High Definition Audio and ATI
Catalyst Control Center)

Thanks

url:http://www.ureader.com/gp/1275-1.aspx

I'm developing a system that uses CF drives in IDE mode. The compact flash
drives support MultiWord DMA 2, but I cannot get XPe to use DMA with the
slave device. I've checked the registry settings that are associated with
the transfer mode, but they seem OK. I've been through the BIOS and can see
that both devices report MultiWord DMA 2 as support. How can I figure out
why XPe isn't allowing the slave device to transfer using DMA.

Thanks,
BK

I used the example from the Xpe help files. It builds quite well. When I go
to run the installed image I get a NTLDR missing.

In reading other blogs, I see that I should also have ntdetect, ntldr, and
ensure the boot.ini is correct. I am very sure the boot.ini is correct. No
where does it say (or I have failed to see it) about the NTLDR or NTDETECT.
My drive is partioned as NTFS.

Quite defeating when you can't get an example to run. I used XPe about 5
yrs ago, thus you could say I am new (again).

Thanks, Rob

Hello

Let’s see if anyone can help me on this.
I am relatively new to Windows Embedded and I have a problem with group
policy.
I’ve added all the components with the words Group Policy, hopping to have
access to all the configurations.
This effort was in vain. When I tried to access Control Panel (User
Configuration - Administrative Templates - Control Panel), the option wasn’t
there.
Is there any way to add all the configurations to my image?

Thanks in advance