...avoit bottle necks. But over several millisecond times the irq and cpu affinities...t helping. At some point in time, hardware gurus have to bite ... rather sacrifice a little cpu time. This is what sticky schedulers ... A chip density like a current Xeon or Opteron would fit ... to be learned by the current coders overnight. This is going ... have been saying that for 5-8 years. It sounds like ...

....com> wrote: On Jun 11, 5:15 pm, "hhc...@yahoo.com"... care about anything but a timely result. Sound tough I know,... 10 volt source, illustrate the CURRENT waveform. [Damn, one right.] Next,...Sketch on the blackboard the current waveform [Two corect] + Finally, your...a pulse generatior procuding 1-millisecond width pulses at a rate...simpy adding the obvious one digit extention to that of my...

....com> wrote: On Jun 11, 5:15 pm, "hhc...@yahoo.com"... care about anything but a timely result. Sound tough I know,... 10 volt source, illustrate the CURRENT waveform. [Damn, one right.] Next,...Sketch on the blackboard the current waveform [Two corect] + Finally, your...a pulse generatior procuding 1-millisecond width pulses at a rate...simpy adding the obvious one digit extention to that of my...

... the window says "This driver is digitally signed." When I hit next, the...>>>> "Use the driver that is currently installed (Recommended); and "Replace the current ... think getting WIA to respond before timing out is the solution? Thanks, ... showed the following: "A timeout (30000 milliseconds) was reached while waiting for a ...

...skyliner...@yahoo.com> wrote: It's the first time I've ever experienced latency recording a single ... SPDIF into an Audiomedia III card (not exactly current) but it's does 24/48. ...you should have a latency down around 5 to 10 milliseconds which will still feel like too much, but welcome to digital. WHOA! You can "feel"/tell a 5 to 10 millisecond latency? By that the case, I...

......@yahoo.com> wrote: It's the first time I've ever experienced latency recording a single... into an Audiomedia III card (not exactly current) but it's does 24/48. ... should have a latency down around 5 to 10 milliseconds which will still feel like too much, but welcome to digital. At 512 samples, I have a latency of about 11 milliseconds at 44.1khz (barely hearable imho)... And ...

...pm, J <skyliner...@yahoo.com> wrote: It's the first time I've ever experienced latency recording a single track on ... the A2D's SPDIF into an Audiomedia III card (not exactly current) but it's does 24/48. That's not the ...API converters. Get a modern interface and you should have a latency down around 5 to 10 milliseconds which will still feel like too much, but welcome to digital.

... window says "This driver is digitally signed." When I hit next,..."Use the driver that is currently installed (Recommended); and "Replace the ... getting WIA to respond before timing out is the solution? Thanks,... the following: "A timeout (30000 milliseconds) was reached while waiting for...as this is the first time I ever saw anything like...

... window says "This driver is digitally signed." When I hit next,..."Use the driver that is currently installed (Recommended); and "Replace the ...\LOCAL SERVICE SID (S-1-5-19) from address LocalHost (Using ... the following: "A timeout (30000 milliseconds) was reached while waiting for ... suggestions about why WIA is timing out? The installation on my...

... window says "This driver is digitally signed." When I hit next,..."Use the driver that is currently installed (Recommended); and "Replace the ...\LOCAL SERVICE SID (S-1-5-19) from address LocalHost (Using ... the following: "A timeout (30000 milliseconds) was reached while waiting for ... suggestions about why WIA is timing out? The installation on my ...